Activity

How to preserve the car lights

1 Examine the airtightness of the headlight

If water vapor invades the headlight, the service life of the bulb might be reduced. Therefore, the sealing characteristics of the headlight ought to be inspected. If the seal ring in the middle of the distribution mirror and the reflector are discovered to be harmed, it must be gotten rid of and replaced instantly.

2 Tidy the reflector

The reflector of the semi-enclosed headlight is blackened and should be eliminated and replaced when the chromaticity is decreased. If there is just dust and stain on the reflector, it can be blown tidy with air compression instead of taking apart and changing. For the reflector that can not be blown tidy, if the reflector’s plating raw material is stainless-steel, because of its high toughness, can use a thin fabric dipped in anhydrous ethanol (composition of more than 95%) from the reflector’s interior to the outside world to thoroughly scrub in a spiral.

If the reflector plating is gold-plated, aluminum-plated film, because of its bad strength, only the neat cotton wool is dipped in boiling water to clean up, not scrubbed to prevent damage to the reflector covering.

Some mirrors are covered with a thin, fully transparent protective movie, so care must be taken not to damage it when cleansing. If the reflector ends up being unclean often, the sealing silicone ring will be damaged and should be eliminated and replaced. After scrubbing or cleaning the reflector, try to dry it before putting it together again, and take note of whether the setup location is appropriate.

3 Clean the bulb

The halogen bulb above the dust and discolorations can be cleaned with alcohol-soaked (90%) cotton. Pay attention not to clean up in the light quickly extinguished, and the bulb still has recurring heat recovery condition. After cleansing, it needs to be drying rather than wiping, do not have to force or towel touch the bulb, does not need to turn on the changing power immediately, or there will be no radiance or can not be repaired.

4 change the direct light orientation

In the whole process of cars and truck travel, the direct light orientation will be shifted because of the vibration of the automobile body, so the annual audit should be performed on the headlights direct orientation of the special check. During the set up maintenance period, professional specialists will likely have to inspect and change the direct beam orientation routinely.

5 After cleaning up the engine compartment, the water ought to be wiped dry

After cleaning the engine compartment, open the engine cover to dry. Keep in mind to wait till the engine compartment dries in the use of cars and trucks. Otherwise, Honda car lights in the engine compartment will become water vapor. It is easy to get in the headlights, leading to the lights can not being utilized usually.

6 routine replacement of light bulbs

If you discover that the lights are not bright enough, you require to replace the lights in time and do an exceptional task of changing both sides at the same time to keep the brightness uniform and guarantee driving security.